Removal Instructions

1.) Use a blow dryer or heat gun and heat up the Vinyl at one edge. Slowly begin peeling it up down the graphic from side to side until all the vinyl is removed. There will be some adhesive still remaining on the surface.

2.) Go to any hardware store and purchase a bottle of liquid adhesive remover and pour into a spray bottle. Spray the surface and remaining adhesive in small sections. Let set for 45 seconds.

3.) The adhesive will begin to liquefy. At this time use your supplied squeegee and scrape the adhesive off and wipe your squeegee into a paper towel each time you scrape.

4.) Once all the adhesive has been scraped off. Spray the surface one more time generously. Wait 45 seconds and wipe off with a clean paper towel each time you wipe.

5.) Now, look down the side of the car, looking for the light reflection on the surface and you will be able to see any slight spots where there still might be some adhesive remaining.

6.) Repeat the above wiping process until you are satisfied all the adhesive has been removed.

Once finished, clean the surface with a mixture of water and alcohol, which will remove any dirt or minuet particles of adhesive unseen by the naked eye.